b. Enter a 0 if you want the person to have to press the start button in order for the bed to turn
on after the session delay. If the session delay ends and the start button has not been
pressed, the time will countdown, but the bed will not start until the start button is pressed.
c. Enter a 2 if you want to set an infinite delay. The session will only start after the person has
pressed the start button, and there is no time limit.
d. Press Enter.
8. The display should read: MGR MAX BED. Enter the number of beds that is on your system
of timers. Then press Enter.
Note: If you only have 6 beds, but are addressed 1,2,3,4,5,and 8; enter 8 on the MAX BED.
9. The display should read: MANAGER NUM.
a. If you are only running one T-MAX Manager Plus/PRO, you can either press 0 then Enter, or
just press Enter.
b. If you are running two or more T-MAX Manager Plus/PRO in a master/slave configuration,
you must set the Master to 0, and the other(s) to a unique address (1~8). You will have to
do this setup on each T-MAX Manager Plus/PRO individually.
10. The display should read: MGR RE-SCAN TIME. Without entering any numbers, press
Enter.
11. The display should read: MAX SLAVE. If you are only using one T-MAX Manager Plus/PRO,
then just press Enter. If you are running a Master/Slave configuration go as follows:
a. Enter the number of the highest number you set any of the managers to. So if you only had
three, and the Master was set to 0, and a slave to 1 and the other slave to 3, the MAX
should be 3. The highest number you can enter is 7.
12. The display should read: SAVING PARAMS. It will re-scan for the timers. Enter your level
1 pass code, then the T-MAX Manager Plus/PRO should be ready for use.
Call/Menu Functions
Pass Code Levels
1. Press the Call Menu button once.
2. Your default codes should have been provided to you with your T-MAX Manager Plus/PRO.
You must enter at least a code of level 1 or higher to send any time to a bed.
3. If a valid code has been entered, there should be an asterisk in the lower left-hand corner of
the display. There will be an asterisk for each level of code.
a. Level 1= *
b. Level 2= **
c. Level 3= ***
RE-SCAN
1. Press the Call Menu button once.
2. Enter 999 then press Enter. After the T-MAX Manager Plus/PRO re-scans, enter you’re
level 1 pass code. The T-MAX Manager Plus/PRO should then be ready for use.
Adding Beds
1. Press the Call Menu button once.
2. Enter your level 3 pass code, then press Enter.
3. Go through like you are doing the Initial Setup, but when you get to MAX BED, remember
to add however many you need.
Note: Remember that if you are using non-consecutive bed addresses, to use the highest bed
address as your MAX BED number.
4. Finish up with your Initial Setup. Let the T-MAX Manager Plus/PRO Re-Scan, and make
sure all the beds are being picked up. Enter your level 1 pass code, then the T-MAX
Manager Plus/PRO should be ready for use.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale